housing ? with pix
03-11-06, 11:06 PM
#1
Engineering Student
Thread Starter
Join Date: May 2005
Location: Tennessee Tech University
Posts: 414
Likes: 0
Received 0 Likes
on
0 Posts
housing ? with pix
ok, got the engine apart enough to see the rotor and housing that failed the compression test, i have not fooled with either, just wondering if you guys could tell from the pix whether or not one of both is bad
thanx
Dennis
more pix at this link
http://www.cardomain.com/ride/2288266/2
thanx
Dennis
more pix at this link
http://www.cardomain.com/ride/2288266/2
Last edited by kanuk93gt; 03-11-06 at 11:10 PM.
03-12-06, 12:32 AM
#2
Looks like both the rotor and the housing are bad.
Some minor marks on a rotor's facees don't matter much, but when he grooves get close to the apexes, it's pretty much a paperweight.
If you can catch a fingernail on the grooves on the housing, it's also bad.
Some minor marks on a rotor's facees don't matter much, but when he grooves get close to the apexes, it's pretty much a paperweight.
If you can catch a fingernail on the grooves on the housing, it's also bad.
03-12-06, 03:46 AM
#3
Lives on the Forum
The apex seal groove needs to be in pristine condition.
In the top two pics, it looks damaged.
Hard to tell about the rotor housing at those angles, BUT...I'm more worried about the ORANGE, RUST-COLORED passages in the water jacket.
This is a sure sign the coolant wasn't maintained, and I would be very hesitant on reusing such internal parts from such a badly maintained engine...
-Ted
In the top two pics, it looks damaged.
Hard to tell about the rotor housing at those angles, BUT...I'm more worried about the ORANGE, RUST-COLORED passages in the water jacket.
This is a sure sign the coolant wasn't maintained, and I would be very hesitant on reusing such internal parts from such a badly maintained engine...
-Ted
Thread
Thread Starter
Forum
Replies
Last Post