Hks Fcd
#1
Senior Member
Thread Starter
Join Date: Jul 2001
Location: Birmingham, AL
Posts: 322
Likes: 0
Received 0 Likes
on
0 Posts
Hks Fcd
Hey all. I am hooking up an HKS FCD to my 89 FC T2. Does anyone know where the install instructions are specifically for the 89+ t2's?
Thanks,
Bryan
www.bnrsupercars.com
Thanks,
Bryan
www.bnrsupercars.com
#2
Opinions are like........
#3
Senior Member
Thread Starter
Join Date: Jul 2001
Location: Birmingham, AL
Posts: 322
Likes: 0
Received 0 Likes
on
0 Posts
Yeah, been to that site. I just need to know which wires are the RPM signal wire and the Pressure sensor signal wire... I don't have a 89 manual to make 100% positive.
#4
RX-7 Bad Ass
iTrader: (55)
Call HKS up - their tech support is top-notch. They will be glad to fax you the manual to the FCD.
It's really basic - you splice into the boost sensor signal and there's two wires that go to power and ground, if I remember right. Way easy.
Dale
It's really basic - you splice into the boost sensor signal and there's two wires that go to power and ground, if I remember right. Way easy.
Dale
#5
Full Member
Join Date: Dec 2001
Location: Huntsville, AL
Posts: 64
Likes: 0
Received 0 Likes
on
0 Posts
Hey Brian, the RPM signal wire is the blue w/yellow wire on the 22 pin connector and the Pressure wire is the green w/yellow wire on the small 16 pin connector. hope that helps. If you need any of the schematics let me know. If Reed ever finishes my Turbo I will be down there.
Later
Dustin
Later
Dustin