ok guys i am having a bit of a problem..

i fitted d2 adjustables into my fc rx7.. but in the front i have come too a problem.. i have fitted and found that when i fit my front guards one side sits lower then the other.. eg one sitting just how i want it and the other being too low and hitting on the guard..

i have measured from the hub too the edge of the body of the car has pictured..




both sides measure too be the same.. but the right hand side is a little bit too low as pictured.



so i have been thinking and thought maybe my chassis is bent in same way.. so i was sitting down looking at my car and noticed the chassis bars that run thru the engine bay slightly look higher then the other..

so i got my levier out and measured between the chassis rails like so



and find that it sages down too the right..



but then i thort that maybe the floor of my garage could be out so i checked, it was unlevel but not by very much..

so was wondering if some one could shead some light on the matter..

i am thinking that my chassis rails are bent so would mean that i should get it up on a chassis straighter and get it fixed quickly so i dont run into problems when it comes too a wheel alignment.?

please help