I have a greddy a/f gauge but one of the harnesses is messed up. The only manuals greddy has are no help, since I need to know the pin layout/or have a picture of it. I even emailed Greddy and they said they didn't really have anything...

So... if someone has one and could help me out it would be much appreciated! I've got to try and get this thing in ASAP so I can run in the next auto-x event.

 

https://www.rx7club.com/showthread.p...=1#post5522960

 

usually red is power, black is ground, other colors are for either narrowband or wideband o2 sensor. Lookup in book

 

I appreciate the response, but that's not the problem. I don't have an issue with the part of the harness that will be spliced into the car... I guess I wasn't very clear.

The other end of the harness, the one that plugs into the "brain" for the gauge, is all messed up. I have the connector, and I have the pins on the wires to go into the connector, but I have no way of knowing which pin goes where. So that's why I need someone else with the same gauge to tell me where the pins go inside the actual greddy connector.