Finishing up putting an S4 n/a rx7 back together and having trouble remembering a few things.

First two pics, where does that circled wire bracket attach?

Next 3 pics, where do they go lol? I'm guessing the first one attaches to the starter so the wire bracket can attach?

Any help is appreciated thanks!

 

first two go together, little gold color bracket goes on bellhousing bolt, wiring harness attaches to it.

not sure about that other one, a wiring harness will go through it. usually Mazda will have a little white piece of tape where a clip or bracket will go, so you'd be looking for that.

 

Awesome! Thanks for your help. Got one more for you. Any ideas?

 

Drivers side intercooler bracket. Bolts down on bracket with hoist point

 

Perfect. Must be a left over from the Turbo II I used to have.

What is the correct orientation for the starter mount bracket? It seems like it could go either way: bolt hole higher, tab lower; or bolt hole lower tab higher?

 

when you tighten the bolt the little tang will keep it from rotating, so you'll have to try it

 

Ah. In that case it would have to be tab lower then so it sits against the block as tab higher would cause it to rotate when turned clockwise.

Thanks again.

Also, I couldn't ever find where the wiring harness mount goes so if anyone seeing this knows, feel free to chime in. Will update if I ever find it.

 

Figured it out. It goes on the the Upper Intake Manifold, circled in red