FelixIsGod29X

iTrader: (50)

I need to finish wiring my accel ignition for my weber carb and dont know anything about the wiring besides the vac set-up. Does anyone have an easy diagram for me to wire this is? Also i have a extrenal fuel pump i can hook up but can i just use a FPR inside the line so i can use the pump in the tank? If theres anyone who can help me out that would be great because once these 2 things are done I can finally use my car.

Aaron Cake

iTrader: (1)

If you get a bypass regulator designed for running a carb in an EFI vehicle, then you can use the stock pump. Mallory makes a bunch of them, as do most of the carb manufacturers. You will need to jumper the fuel pump test connector at the passenger shock tower (yellow connector) to allow the pump to run without the AFM.

For your ignition, check the instructions that came with the box. It will have a wiring diagram or two.

FelixIsGod29X

iTrader: (50)

I dont have the box of instrustions it came on an old car of mine that im using on another car. I think it will be easyer for me to set up the extrenal pump I have. BUT I STILL NEED A DIAGRAM! HHHEEELLP

Aaron Cake

iTrader: (1)

Call Accell and have them send you the instructions? Or check their website?

FelixIsGod29X

iTrader: (50)

went to accels site, they had instructions but they were very crappy and i dont think it was the whole thing. Set them an e-mail about instuctions but i have no clue how low its gonna take. I would rather get help from someone on here. ....anyone?