2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Help Help Help!!!

Thread Tools
 
Search this Thread
 
Old Jun 18, 2007 | 02:34 PM
  #1  
HIDrift's Avatar
Thread Starter
KARNAP!
Tenured Member 05 Years
iTrader: (5)
 
Joined: May 2007
Posts: 49
Likes: 0
From: 93311
Unhappy

i have a 90 fc w/ auto trans. i converted it to manual trans. and replaced the motor w/ a four port s4 motor. i used the s5 harness. theres no emission hooked up. my problem is i cant full throttle it. it sounds like theres no fuel only on full throttle. partial throttle is ok car starts fine. already replaced tps, crank sensor
fuel pump. have no intake or vacuum leak. i also tried another s5 ecu. maybe som e of you guys have or had the same problem. pls. help! im stuck... thanks

and I still have a 90 fc w/ auto trans. i converted it to manual trans. and replaced the motor w/ a four port s4 motor. i used the s5 harness. theres no emission hooked up. my problem is i cant full throttle it. it sounds like theres no fuel only on full throttle. partial throttle is ok car starts fine. already replaced tps, crank sensor
fuel pump. have no intake or vacuum leak. i also tried another s5 ecu. maybe som e of you guys have or had the same problem.

Last edited by mar3; Feb 9, 2010 at 02:33 PM. Reason: Merged back-to-back posts...
Reply
Old Jun 21, 2007 | 02:34 PM
  #2  
sunshine's Avatar
Rotary Freak
Tenured Member 20 Years
iTrader: (3)
 
Joined: Feb 2002
Posts: 1,697
Likes: 0
From: MN
Limp mode due to missing OMP?
Run the codes...if you can on that frankenstein.
-a
Reply
Old Jun 21, 2007 | 03:03 PM
  #3  
drizzle's Avatar
Newbie
 
Joined: Jun 2007
Posts: 3
Likes: 0
From: Winston-Salem, NC
you have to use the S5 front cover and oil metering pump or they will not rev.
Reply
Old Feb 20, 2008 | 08:21 PM
  #4  
HIDrift's Avatar
Thread Starter
KARNAP!
Tenured Member 05 Years
iTrader: (5)
 
Joined: May 2007
Posts: 49
Likes: 0
From: 93311
Help Help Help!!!

i was reving the engine to above 7k rpm at idle and at my 4th rev. the motor started shaking like crazy. it feels like the engine isn't balanced. now the whole car shakes on idle, accel. and deccel. i checked the pulleys, mounts, injectors, and flywheel and everything seems to be ok. motor has been converted from a 6 port to a 4 port w/ new rear rotor and housing. it has about 6k mi. on it and always ran good up till now. has anyone ran into this kinda problem before or have any advice??? im hoping its not internal. can anyone help me???
Reply
Old Feb 20, 2008 | 09:47 PM
  #5  
Soma's Avatar
I knw wht u did last sumr
Tenured Member 05 Years
 
Joined: May 2006
Posts: 356
Likes: 0
From: AZ
I would be thinking about doing a compression check next.
Reply




All times are GMT -5. The time now is 10:14 AM.