Hard work (paint, engine, etc.)
#1
Full Member
Thread Starter
Join Date: Apr 2002
Location: atlanta
Posts: 129
Likes: 0
Received 0 Likes
on
0 Posts
Hard work (paint, engine, etc.)
hey,
just thought i share some pics of my FC tat ive been working on and off for tha last two years. i did the whole paint job myself and dropped in a S5 motor while i was at it. Sadly, its for sale here:
https://www.rx7club.com/showthread.p...37#post2771437
and my gallery is here:
http://www.prism.gatech.edu/%7Egte61...20TII/phu.html
enjoy
just thought i share some pics of my FC tat ive been working on and off for tha last two years. i did the whole paint job myself and dropped in a S5 motor while i was at it. Sadly, its for sale here:
https://www.rx7club.com/showthread.p...37#post2771437
and my gallery is here:
http://www.prism.gatech.edu/%7Egte61...20TII/phu.html
enjoy
#3
Full Member
Thread Starter
Join Date: Apr 2002
Location: atlanta
Posts: 129
Likes: 0
Received 0 Likes
on
0 Posts
thanks. s5 moldings was TOOO expensive and tat exhaust was how it was wen i got the car, if u look closer, it has white paint all over it, cuz i didnt even bother masking it up. that crap isnt on dere anymore
#5
Do a barrel roll!
iTrader: (4)
Is that a pacesetter cat-back? I used to have one on my FC (got it dirt cheap when my stock one was rusted out..) It took a good bit of modification for me to get it to sit even and level. Good think Im handy with a cutting wheel and a welder.. Here are a few pics of mine when I had it. It sounded ok...until I got a header.
Thread
Thread Starter
Forum
Replies
Last Post