anyone know where to find in the FSM a diagram that shows the route of all the hard brake lines? or anywhere online?

 

The FSM doesn't show much detail, just a general overview. What exactly are you looking for?

 

im looking for a "map" of the route the hard brake lines take

 

For the whole car?

Have another car you can look at?

Maybe by looking at some of the pics in the Haynes manual, i.e. the underbody shots and strut or brake related pics...

 

its pretty simple ok it runs under neath from ware the hand brake is located it will be one wire that gose to right about ware your dif is and will split in to 2 wires one goes to the left brake and one goes to the right brake not to hard to see black wires about 1/4th inch thick give or take 1/8th of an inch

 

i need to replace the drivers side brake cabel it snaped right at the little T that it hooks to the brake with

good luck wiht fixing your brake yo u can get new cabels for about 22 a pice from oriles

 

o and i just thought of this you might as well replace them all wile your at it because if you have a new cabel its going to hold more then the old cabel so the other cabels will probably starte to go IMO (logicaly thats what would happen) and if you do replace them all you will not have to worrie about them for a wile

 

i wasnt looking for info on the ebrake cable. i was looking for info on the hard metal brake lines. but i just went out and looked at them. if i only have to do the fronts it wont be too hard