I have been searching and could not find the PDF. It seems as if rotaryres. had hosted it at one time but the link is dead.

I just bought the kit but I am on the road for the next two weeks. Wanted to look over the directions and compare it to the RXTuner write up!

I tried stumbling around the Trust site with no luck

James

 

PM me your e-mail address - I'm the guy that originally scanned it in ages ago .

Dale

 

I just installed it last weekend. I didnt do a full write up but everything is pretty self explanatory. My write up was focused more on installing it with the bumper reinforcement. Most people have said it's not possible or feasible but I did it.

https://www.rx7club.com/2nd-generation-specific-1986-1992-17/greddy-vspec-fmic-install-w-bumper-reinforcement-372301/

 

Thanks man...I have read over your post.

I do not want to cut the bumper hole bigger though. Would that change things ? Could I still use the support?

And good job keeping the support!

James

 

That's where I made my mistake. I originally fitted the support and it didnt fit until after I modified some things. I cut the bumper before I got the support to fit and yes you can cut less of the bumper, I wish I did. You will still have to trim the side ducts alot and some of the center section. Just not as much as I did.