RX7Club.com - Mazda RX7 Forum

2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:
Banzai Racing

gotta do it

Thread Tools
 
Search this Thread
 
Old 07-29-08, 11:06 AM
  #1  
Junior Member

Thread Starter
 
chuckrx's Avatar
 
Join Date: Jul 2004
Location: New York
Posts: 18
Likes: 0
Received 0 Likes on 0 Posts
gotta do it
I hate to, but I have been toiling in front of this computer searching for the last hour and I have gotten no where. I have installed my a/f controller and wish to use the pressure sensor wire instead of tps. So, as one may have guessed; I have an s4 non-turbo and I would like any help- preferably a diagram or sketch cause I'm an idiot- on locating the pressure sensor wire at the ecu. Thanx a buch
chuckrx is offline  
Reply Like
Old 07-29-08, 12:59 PM
  #2  
Engine, Not Motor

iTrader: (1)
 
Aaron Cake's Avatar
 
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes on 91 Posts
Don't use the stock boost sensor.

Get a GM style MAP sensor and use it instead. Pressure vs. voltage curves for these sensors is all over the 'Net.
Aaron Cake is offline  
Reply Like
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
hogged out vs boost prepped (Nikki)
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
Back to Subforum
2nd Generation Specific (1986-1992)
View Next Unread
where does the a/c compressor clutch plug in?




Advanced Search
Quick Reply: gotta do it


Reply Closed Thread Share

All times are GMT -5. The time now is 10:33 AM.