^_^
got a AVC-R but dunno how to install
my car is 87 t2 but changed 91 turbo so there is no swtching actuator only have a wastegate valve.
when I read the manuel of AVC-R they talk about actuator I think should be the switching actuator but I dont have it already. but the wastegate part(AVCR manuel) shows a aftermark wastegate.
So the problem is I dont know where should I connect about the AVCR solenoid valve.
need you guys help please.

thx a lot!!!!!

oh another problem. the wires witch connect to ECU has a PUPLE wire connect to (RPM signal . Injector Signal). but my ECU's those wire are two point. So should I connect to RPM or Injector???

thx again....

 

help plz

 

Since you have a hybrid, i have no idea whether you installed the stock electronic boost controller with your new engine or not. If you didnt, and your compressor housing has a metal line between the wastegate and the outlet nipple, then what you need to do is run a vacuum line from each of those nipples to the respective nipple on the AVCR solenoid.

 

i tried following this
http://www.fc3s.org/how_tos/electrical/avc.html
but alsohave the same issue with the wires on the ECU but mine is an 89