Giving the Logicon a new power source
#1
Giving the Logicon a new power source
A while back I was fiddling around with changing out the entire blower motor assembly on my car. IN the process I bumped the jumper I had on the EX-HI relay and power to the blower motor and Logicon was lost. The big Red/yellow stripe wire no longer had power when the ignition was on.
I routed a power wire to the a wire that's on the Radio fuse, so the Logicon comes on with the key in the ACC position. BUt if I turn the fan speed above %50 the fuse blows.The clocks gets drained too so it's difficult to see.
So does anyone know a good wire to splice into to get power for the Logicon and blower again? Or if you know of something that may have blown along the original circuit when it shorted that would be VERY helpful. Maybe a Relay somewhere went out>? I do have a parts car too, but couldn't solve the power issue the 1st time through.
I routed a power wire to the a wire that's on the Radio fuse, so the Logicon comes on with the key in the ACC position. BUt if I turn the fan speed above %50 the fuse blows.The clocks gets drained too so it's difficult to see.
So does anyone know a good wire to splice into to get power for the Logicon and blower again? Or if you know of something that may have blown along the original circuit when it shorted that would be VERY helpful. Maybe a Relay somewhere went out>? I do have a parts car too, but couldn't solve the power issue the 1st time through.
Thread
Thread Starter
Forum
Replies
Last Post
sherff
Adaptronic Engine Mgmt - AUS
9
02-24-19 12:09 PM