genral front mount install how to?
#1
Rotary Enthusiast
Thread Starter
genral front mount install how to?
hey al li got a isuzu npr large front mountthat i am gonna be installing here in a few weeks. from the outside of one pipe to the other pipe and from the tip on one mount to the tip of the other mount it is 29.5"x17" so its fairly big. i was wondering if there was a general how to or tips and tricks to doing this? like form looking in there i can tell that soem stuff is gonna have to be relocated. but i was jsut wanting and info that anycould provide or post a link to. i wil lbe happy to take more mesurements/pictures upon request.
#3
Brother of the Rotary
iTrader: (2)
How tall is that FMIC. It looks very tall.
What you could do it make a mouting bracket at the top of the IC that attaches to the front crossmember.
You could also add side supports that drill into the frame on the bottom, similar to what I did.
you can see them here
What you could do it make a mouting bracket at the top of the IC that attaches to the front crossmember.
You could also add side supports that drill into the frame on the bottom, similar to what I did.
you can see them here
Thread
Thread Starter
Forum
Replies
Last Post