Hi guys,

I've purchased a Gen 1 APEXi Super AFC for my 1991 Series 5. Downloaded the manual from apexi-usa but can't seem to find the vehicle and air flow type selection switch for our cars (Switches on the back side of controller). The table only show FD's setting but not FC.. Could anyone pls help me on this? Cheers.

 

http://www.1300cc.com/howto/how2/safc.htm

 

thanks a lot dude.. but I got the Gen 1 five ***** style.. there r this row of switches behind that need to be set in for specific vehicle.. probably to take in the voltage range of the air flow meter... and cylinder setting..

 

damn, sorry i thought there was only 1 version of the SAFC1. the settings should be similarly setup as to this version but you may have to compare them with how the settings are described in the manual. it is a flap type of sensor, it is a low to high voltage TPS netting the up and to the right arrow, setting is for a 4 cylinder engine. should get you an idea but if there is no descriptions about the settings in the manual then i would wait for someone who has one of the older versions to post up.

 

No worries dude.. It is just a simple row of 8 switches with On/Off and a diff combination for diff cars, no labelling or watsoever on what the specific switches are for.. I think Americans are still playing with the V8 muscle cars when this model came out.. hahahaha Thanks btw

 

lol np even though i wasn't of much help.

 

Oh... My mistake .. it says on the manual below MAZDA section that Air Flow Meter does not correspond FLAP type.. F**K!!!! Looks like I got to get the more costly one...

 

http://fc3spro.com/TECH/MODS/EL/FUELCON/APEXI/afc.htm

Try pot set to "4" first.
I know this will work with Zenki FC turbos...


-Ted