Nearly completed putting my turboII back together but I have a couple questions of lines I just cant seem to find in any of the haynes or online FSM.

On the Water pump at the base is a line that fall directly below the Alternator, where does this fellow wanna connect to?

Last two are on top of the UIM and Throttle body on the back side(firewall side) Where does those two need to be fed to?

Thanks and again, I wish I was the one to take this stuff apart sure would have been easier to put together.

 

The coolant lines are shown on page 3-3 of the FSM Cooling System chapter.

Coolant flows from the nipple of the rear plate to the bottom of the thermowax on the TB, then from the nipple on the top of the TB to the rear nipple on the BAC valve, then from the front nipple on the BAC valve to the nipple on the back of the water pump.

There's no coolant in the UIM.

 

Perfect, was looking at FSM 3-3 the whole time it just never hit me to understand it properly. Makes sense now. Thanks again your saving my tail like you wouldnt believe