FD fuel rails on an FC
#1
Brap Brap Brap
Thread Starter
Join Date: Nov 2007
Location: Minneapolis, MN
Posts: 314
Likes: 0
Received 0 Likes
on
0 Posts
FD fuel rails on an FC
Will REW style fuel rails work on an S5 motor. I found a pair of SARD rails with all the fittings, block off plates and everything else for $200. Brand new too. A buddy of mine got them about a year ago, but ended up having a custom setup built by Moran.
Just wanna know about fitment differences on FC and FD motors. If the will fit, then Im golden.
Just wanna know about fitment differences on FC and FD motors. If the will fit, then Im golden.
#3
Brap Brap Brap
Thread Starter
Join Date: Nov 2007
Location: Minneapolis, MN
Posts: 314
Likes: 0
Received 0 Likes
on
0 Posts
http://www.rhdjapan.com/sard-aluminu...-13b-rew-25594
Im 99% sure these are the ones.
so its a no go?
Im 99% sure these are the ones.
so its a no go?
#4
rotorhead
iTrader: (3)
Those are aftermarket top feed rails. Fitment wise, the main concern is whether the bolt holes are spaced appropriately, especially on the secondary rail. Also, these are most likely for Bosch-style injectors which have a larger o-ring and diameter than the factory Denso top feed injectors. That presents its own set of issues, because if you don't install them right there will be a vacuum leak. What injectors were you planning on running? What is your setup? Do you really need aftermarket rails?
Those blockoff plates are going to be useless for you. If you've ever looked under the UIM of an FD you would see that they are FD-specific.
Those blockoff plates are going to be useless for you. If you've ever looked under the UIM of an FD you would see that they are FD-specific.