FC3C Turbo starting problems
01-24-05, 07:25 PM
#1
Newbie
Thread Starter
Join Date: Jan 2005
Location: Australia
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
FC3C Turbo starting problems
Hi guys,
I've done some searches and come up with nothing, but that could be my searching technique.
Basically I have just imported a Japanese spec series 5 RX7 convertable and am having some major problems getting it started.
When I start the car it runs for like 5 seconds then cuts out. I'm not sure if its fuel and spart or just fuel (I will check that when I get home).
I believe these cars have the ability to give you an ECU error code, via the check engine light. But I havent seen anything!!! The check engine light has not even come on!
2 more possible causes are the alarm (which I am pretty sure is ok, as it starts and seems to function correctly) and I believe an AVCR boost controller was stolen from the ship this couldnt cause the engine to stop if it was badly removed could it?
Thanks in advance,
Richard
I've done some searches and come up with nothing, but that could be my searching technique.
Basically I have just imported a Japanese spec series 5 RX7 convertable and am having some major problems getting it started.
When I start the car it runs for like 5 seconds then cuts out. I'm not sure if its fuel and spart or just fuel (I will check that when I get home).
I believe these cars have the ability to give you an ECU error code, via the check engine light. But I havent seen anything!!! The check engine light has not even come on!
2 more possible causes are the alarm (which I am pretty sure is ok, as it starts and seems to function correctly) and I believe an AVCR boost controller was stolen from the ship this couldnt cause the engine to stop if it was badly removed could it?
Thanks in advance,
Richard
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
sherff
Adaptronic Engine Mgmt - AUS
9
02-24-19 12:09 PM