FC Fitment
#1
Junior Member
Thread Starter
Join Date: Sep 2020
Location: Australia
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
FC Fitment
It's probs been posted a million times, But for my FC I found a set of rims that are 17x9 and 17x10 both +30 offset, Question is with rolled guards will these fit and if so what tyre sizing will I need?
Secondly if not there is another identical set but 17x8 +20 and 17x9 +30, Same question,
Or Which size would suit best for a square set (ie 17x9 +30 all round)
Thanks.
Secondly if not there is another identical set but 17x8 +20 and 17x9 +30, Same question,
Or Which size would suit best for a square set (ie 17x9 +30 all round)
Thanks.
#2
Rotary Freak
FC3S Pro v2.0: Mods - Rims
Looks like both sizes you mentioned should fit.
EDIT: I misread your post, sorry. The first set won't fit without overfenders. The second set is closer to fitting but you may need a spacer in front. For a square set at 17x9+30, you would need spacers and overfenders in front, rear would fit.
Looks like both sizes you mentioned should fit.
EDIT: I misread your post, sorry. The first set won't fit without overfenders. The second set is closer to fitting but you may need a spacer in front. For a square set at 17x9+30, you would need spacers and overfenders in front, rear would fit.
Last edited by WondrousBread; 01-16-21 at 07:57 PM.
#3
Junior Member
Thread Starter
Join Date: Sep 2020
Location: Australia
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
#5
Full Member
iTrader: (1)
All the sizes mentioned would fit on stock front and rear fenders, if you have front camber adjustment and being careful with tire selection. If you have extended front control arms the min offset I could run was 18x9 et 20 or the rim would hit the coilover. -6.5 camber (I am also stock front and rear fenders)
Thread
Thread Starter
Forum
Replies
Last Post