2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

this is F*#k%d up??

Thread Tools
 
Search this Thread
 
Old Apr 25, 2002 | 11:43 AM
  #1  
drake696's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Mar 2002
Posts: 87
Likes: 0
From: kamloops
Question clutch question??

ok lete see if any of u can tell me whats going on here first my secondary fuel in jectors are not kicking in and my clutch only works when it's cold once the car warms up it wont let me put it into gear and the clutch wont release.

Last edited by drake696; Apr 25, 2002 at 04:27 PM.
Reply
Old Apr 25, 2002 | 12:47 PM
  #2  
drake696's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Mar 2002
Posts: 87
Likes: 0
From: kamloops
what nuthing not even a guess ???
Reply
Old Apr 25, 2002 | 04:02 PM
  #3  
Jeff Blythe's Avatar
Newbie
 
Joined: Apr 2002
Posts: 1
Likes: 0
From: Dallas, Texas
Clutch question

Have you checked both the master and release cylinders for the hydraulic system? I've had four RX7s and each one of them did that at one point or another. I have found the problem is usually a bad release cylinder (which is down by the bell housing for the transmission-driver side).
Reply
Old Apr 25, 2002 | 04:23 PM
  #4  
drake696's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Mar 2002
Posts: 87
Likes: 0
From: kamloops
but it workes with absolutly no probles what so ever when it's cold
Reply
Old Apr 25, 2002 | 06:42 PM
  #5  
Ranzo's Avatar
Senior Member
Tenured Member 05 Years
 
Joined: Mar 2002
Posts: 666
Likes: 2
From: Memphis, Japan
You should check both the master cylinder and the slave cylinder(release cylinder) and make sure they are working properly. If they are then maybe its time to pull the mission and check the clutch itself. This sounds like a slave cylinder to me.

The first time you try to push the clutch in it works but after pushing it all the fluid has seeped past the dying seals in the cylinder causing it not to work properly or the heat of the engine is causin the seals to fail.


Secondary injectors? what leads you to believe they are not working?
Reply




All times are GMT -5. The time now is 12:14 AM.