I just ordered 2 parts from Racing Beat for my Turbo II:

Fuel Cut Controller


And a 3.15 inch down pipe.


I hope to install them this week. I still have to port out my wastegate and get a 3" custom echaust done. Will this run fine without any other problem?

What type of PSI do you think I will be pushing and how much HP should I get?

Thanks.

 

you will most likely get about 10 - 11 psi. but that is assuming that you have a good intake like cold air.. with as little restriction as possible as it does make problems. when you have a high flowing exhaust yet a restrictive intake. such things like compressor surge.