Sorry all, its been a long *** day .. and a long rebuild, I can’t recall where these go too. I wooked through the FSM but nothing stood out.. can someone enlighten me, or tell me what chapter or page of the FSM covers this.

THX a lot.

Robert

 

damn i wish my engine block was that clean.

 

The top picture is a coolant line that goes to the back of your Throttle body I believe.

 

13bpower is correct....unless you've done the TB mod and then it should be rerouted to the BAC. Also, make sure to use a preformed 90 degree piece of hose on that nipple....a straight piece won't be able to bend right.

 

2nd picture is to the heater core, the one on the left should come from the lower-radiator arm and follow along the frame and then go up and plug in there. The other gets plugged into the plug in picture 3.

 

So I want a 90 to go 90 deg. backwards *right* off the nipple? or up a ways? (Pic 1)


Jacob.. thats just hand scrubbing during the rebuild I didn't take the time to paint it or it would look really clean.