I got a european turbo2 88mod and an engine from a jp turbo2 88mod.
I`ve tried to find out where to connect the connectors (at the emission harness) to the front harness. (yes i got the FSM for the L/H T2).
Is it different colored wires on the jp version ? (i really hope soo)
If so where can i find a FSM to the jp version ?
The jp version aint got the connector to the wiper engine too.
Maybe there is a turtorial for engine "swap"....

 

I also need a new connector. Its the big one that goes from the front harness to ECU. Is it possible to buy only the connector? (where?)

 

Jspec and Aspec harnesses are different because of the LHD/RHD difference. So I am assuming if you have a LHD car like US models you need to swap over your harness so that the plugs reach.

 

okey, but its hard to get the us harness. It would be much better for me if there was a way to rebuild the Jspec harness

 

Can't you use your old harness, whats wrong with it? It should work well unless its dammaged somehow. Any LHD harness from the same model/series. I believe a couple of guys have rebuilt their j-spec harnesses to work but that sounds like a lot of labor.

 

I dont have any old harness. The only harness i have is the one on the engine, and thats a Jspec engine..