engine mount differences
#1
Full Member
Thread Starter
iTrader: (2)
Join Date: May 2009
Location: SoCal
Posts: 93
Likes: 0
Received 0 Likes
on
0 Posts
engine mount differences
This is probably a noob question and been answered a 1000 times. Well i just dropped in a s4 turbo keg into my s5 vert. The engine mounts went in and look like they are all bolted up nice. Once i got up to to look at it, it looks as if the engine is not on centerline. Seems like the front of the engine points too far to the left. I was measuring it vs my old s5 n/a engine, and it seems like the part that bolts up to the bottom of the engine that holds the motor mount is about a .5" shorter on the s5 n/a, or maybe i am just measuring wrong. I think you will be able to see it in the picture refrencing off of the hood latch how far off it is.
#4
Full Member
Thread Starter
iTrader: (2)
Join Date: May 2009
Location: SoCal
Posts: 93
Likes: 0
Received 0 Likes
on
0 Posts
So I do need to change that aluminum cast mount cause its sitting level right now. If I put a bubble levle on the intake exhaust side front plate it reads level. Just looks like the engine is pointing to the left side to me. If you sight the tranny split to the firewall it says it points to the left.
Last edited by 90socalvert; 01-02-14 at 06:58 PM.
Thread
Thread Starter
Forum
Replies
Last Post
immanuel__7
2nd Generation Specific (1986-1992)
89
09-05-15 10:23 AM
KAL797
Test Area 51
0
08-11-15 03:47 PM