engine building help?
#1
Full Member
Thread Starter
Join Date: Jun 2004
Location: Lewistown, PA
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
engine building help?
need some help, gettin ready to rebuild my 13b n/a 6 port. I need to build this engine to hold boost, so my question basically is, can i install turbo 2 rotors to lower my compression for more reliable boost? Would i need to install any other T2 parts to go along with the t2 rotors for it to work(ex. t2 intake, t2 flywheel, t2 eccentric shaft?)
Any help would be greatly appreciated
oh yeah, the setup i am goin to run is gonna consist of T60-1 turbo, tial 50mm wastegate, big fmic, water injection, afc2, walbro 255, and 760cc injectors. plus possibly a few other goodies. Want to be able to run atleast 8psi daily and maybe turn it up to like 10psi everyonce in a while.
Any help would be greatly appreciated
oh yeah, the setup i am goin to run is gonna consist of T60-1 turbo, tial 50mm wastegate, big fmic, water injection, afc2, walbro 255, and 760cc injectors. plus possibly a few other goodies. Want to be able to run atleast 8psi daily and maybe turn it up to like 10psi everyonce in a while.
#2
Banzai Racing
Yes, you can install the TII rotors which will allow you to boost an N/A engine more reliably. The Eshaft is the same. You can only install the TII flywheel if you are installing the TII trans. The intake ports of the TII LIM will not line up with the ports on a 6port block.
You should consider installing a TII oil pump, TII front engine cover for the oil return line, and drill and tap the front plate for the turbo oil feed line.
You should consider installing a TII oil pump, TII front engine cover for the oil return line, and drill and tap the front plate for the turbo oil feed line.
Thread
Thread Starter
Forum
Replies
Last Post
immanuel__7
2nd Generation Specific (1986-1992)
89
09-05-15 10:23 AM
rx8volks
Canadian Forum
0
08-13-15 04:55 AM