ECU Terminal 2C ground
#1
Newbie
Thread Starter
ECU Terminal 2C ground
So I'm going through and verifying terminal connections. The manual says 2C should be a black wire that's grounded... couple of problems.
Problem 1: The 2C wire is Brown/Black. Good news, I was able to verify that my throttle sensor, variable resistor, pressure sensor....etc share the same Brown/Black wire.
Problem 2: I cannot find anywhere in the harness where the 2C wire (Br/B) would connect to the B (Em) wire as shown in red below. Can anyone confirm this?
EDIT: I have a 87 Turbo II by the way. I'm looking at the wiring for the N/A version which doesn't have the red line shown above. Was there a difference between years?
Problem 1: The 2C wire is Brown/Black. Good news, I was able to verify that my throttle sensor, variable resistor, pressure sensor....etc share the same Brown/Black wire.
Problem 2: I cannot find anywhere in the harness where the 2C wire (Br/B) would connect to the B (Em) wire as shown in red below. Can anyone confirm this?
EDIT: I have a 87 Turbo II by the way. I'm looking at the wiring for the N/A version which doesn't have the red line shown above. Was there a difference between years?
Last edited by neova; 12-16-18 at 07:14 PM.
Thread
Thread Starter
Forum
Replies
Last Post
turbowash
2nd Generation Specific (1986-1992)
9
09-28-13 11:20 PM
WonkoTheSane
2nd Generation Specific (1986-1992)
10
08-04-10 08:07 PM
JONSKI
3rd Generation Specific (1993-2002)
6
08-04-02 11:42 AM