ECU Grounds Question
THE TOP END GROUND WIRE FROM THE ENGINE... go's to what ground wires on the ECU Plugs?
Only Reason im asking. is im thinking about Running a Good Clean ground down to it.. if this is even a good idea.. the ECU ground is the only one i have yet to be able to get to without ripping the upper intake off.. and just dont have a way to do that |
Pin 3G,3A,2R and 2C.
|
you're awsum
|
is it safe to Ground all these to a Single Ground?
|
Originally Posted by cyberxn
(Post 10502010)
is it safe to Ground all these to a Single Ground?
|
would it help though?
|
Having a good set of grounds is the foundation for a good electrical system or are you asking if the ECU bolts are a good grounding source. If so, then yes, they most certainly are a good source.
|
Awsum. Last thing i need.. and may be noobish of me... is a Diagram of Each ECU Harness Plug...
Unsure of the location of Pin 3G,3A,2R and 2C.. or if there's a counting Method that be awsum. |
Originally Posted by cyberxn
(Post 10502050)
Awsum. Last thing i need.. and may be noobish of me... is a Diagram of Each ECU Harness Plug...
Unsure of the location of Pin 3G,3A,2R and 2C.. or if there's a counting Method that be awsum. |
DONE DONE AND BWAAA!??..!
ok so i did this. Found that someones had there hands on it due to the Tape and Crimped wires i found.. not exposed.. just crimped. Took it back out for a Drive.. Fail.. it was the same.. so i took my Test LED lamp and Put it to the Test Lead for the TPS.. Warmed all the way up With the Key in the ON position, found Both LED's Lit. Touched the Throttle a little and one went out. SO. i set it to where one light was lit. Taped the Gas a Couple times to make sure the 2nd didnt come back. and took it back out for another spin. THIS TIME.. It tried to kick on the 2nd injectors But the Car was bouncing around a bit due to it leaning out and coming back... Not sure where to go from here. i do have another Post In the same Boat as this one https://www.rx7club.com/2nd-generation-specific-1986-1992-17/led-tps-fix-help-944406/ Any help here would be great. The ECU is as about as Apart of the Ground as the Entire Car.. Also note that the car has a Ground Kit on it.. ive got all the key points Routed back to the Ground on the Battery |
Pin 3H (front) and pin 3F(rear) are the pins for the secondaries. If you put the negative LED wire into the back of 3H and the positive LED wire into the back of pin 3I or 3J and either drive the car or leave it in the driveway with it set up for load as previously done then you can push the car past the 3800 rpm level and if the ECU is firing the signal to the secondary injector then the light will quickly flash. No flash means the ECU is the cause. Do this for both injectors.
Some more info: https://www.rx7club.com/showthread.p...dary+injectors |
Another Question... just got back from a Horrible ride.. took it out for a small trip maby 20 miles or so.. on the way back Pushing WOT in 2nd it got upto 3800 And Just went Nuts. Backfiring, Hesitating and so on... so.. at the light i WOT Reved it Twice. Hit 3800 And sounded like it hit a rev limiter.. IF the 2nds are not Kicking on at all would this be a Cause?
Also seem to of lost a good deal of power from 1.5 to 3.8 now.. not sure what the deal is.. But i will run this Test as soon as possible ALSO. what are the wires to the Primary? |
1 Attachment(s)
............. Took the cover off the ECU a little bit ago and noticed something odd.. just now in one of the Photo's i took of the Wire count
Attachment 722977 RIGHT Above 2M.. there's a Fat Resistor there... which Seems Burned.. Any clue what that Possibly would work with? |
Originally Posted by cyberxn
(Post 10502245)
Another Question... just got back from a Horrible ride.. took it out for a small trip maby 20 miles or so.. on the way back Pushing WOT in 2nd it got upto 3800 And Just went Nuts. Backfiring, Hesitating and so on... so.. at the light i WOT Reved it Twice. Hit 3800 And sounded like it hit a rev limiter.. IF the 2nds are not Kicking on at all would this be a Cause?
Also seem to of lost a good deal of power from 1.5 to 3.8 now.. not sure what the deal is.. But i will run this Test as soon as possible ALSO. what are the wires to the Primary? |
Originally Posted by satch
(Post 10502276)
Front is 3E and rear is 3C though your primaries have to work for the car to run but the secondaries come on at 3800 and that's likely your problem.
|
Originally Posted by cyberxn
(Post 10502285)
any word about that Resistor in the pic?
|
OK SO .... I built this Nifty LED Thing... Out of 4 LED's and an Eye glass Case that im Pretty happy about.. that shows the Primary's and the 2nds.. Tested in the Driveway. 2nds work perfect. Took the car out onto the road... for no reason.. the Car Was a rocket.. no issues.. NONE...
SO i WAS LIKE... ok.. to Daytona Beach then... Got up on the highway... Pri and Secs Lit and Felt perfect. No hesitation no NOTHING.. then half way there when the car Got Warmed all the way up.. and the Spark Packs warmed all the way up . AS SOON AS THE 2nds KICKED IN... POWERLOSS AND HESITATION. Little more Driving on the Primary's Under or upto 3K and the car Felt as if it had Lost power.. NOW.. on my CRUDDY Short ban O2 sensor. When this happens Its lean Enough not to Show up on the Gauge. Same thing on the 1-3K on the Primary Which makes me wonder if its an Issue with Both Sparkpacks NOT firing Correctly. WITH THAT BEING SAID. i do have NEW Sparkplugs and Cables Installed and running 93 Octane with Lucas Fuel Injector Cleaner... ANY type of help here would be awsum WOULD THE SPARK PACKS HAVE THIS KIND OF IMPACT.. and ... Do they like cake?... no srsly though... Could they cause this? My Idea on this would be Faulted by the fact that i thought improper Fire would Make it rich |
Might want to compare your results with another day of driving and see if there are any similarities such as the car operates properly when cold but not warm. Secondly, you don't need high octane gas at all. Thirdly, do you have factory coils or an aftermarket setup? So when the car is problematic will the lights flash when the secondaries are supposed to come online. A restrictive/clogged exhaust might be a cause for your problem but then it could be something totally unrelated. I've also seen a clogged fuel filter create the same results when it looked like the fault was something else. Also, try the simulating load in the driveway and see if you can get the car to behave properly and if so then maybe you should look over the Pressure Sensor.
|
its stock packs, straight pipe systems with a precat. and i just so happen to have a new filter i can install tomarrow. and the high octane was a troubleshooting step on my part.. as with the lucas.. but if it is the coils is there a chance of it doing this?
and yes the 2nds to light up ADDing to this an exsample if im moving at 45 at 3.5K and the pri's are lit and i push it enought to kick the 2ns on as soon as there lit the cars hesitates and flops aroundlet off the gas and its good. ill still do the filter swap |
OK WELL....... Im so pissed... yet im so happy.. pissed that.. i didnt do the Filter First... Happy... due to the fact that its running 300% better...
When i shook the old Filter... it Rattled... when i removed it.. it Backwashed.. what i think is Rust.. here's a Pic of the nastiness <a href="http://s97.photobucket.com/albums/l235/cyberxn/?action=view&current=030811151014.jpg" target="_blank"><img src="http://i97.photobucket.com/albums/l235/cyberxn/030811151014.jpg" border="0" alt="Photobucket"></a> Gas in the Filter was SICK..... Gas coming from the tank was clear and clean.. Replaced it... and 0 issues.... I cant Full Understand the hot cold deal.. or how it has ANYTHING to do with the Filter.. but its working.. well Thank you so much, with the help ive Grounded the ECU and basically Did a Short Tune up |
All times are GMT -5. The time now is 05:21 PM. |
© 2024 MH Sub I, LLC dba Internet Brands