driveshaft
#1
Junior Member
Thread Starter
Join Date: Oct 2005
Location: Richmond, CA
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
driveshaft
i have a 1988 gxl, my driveshafts rear is gone...i needa replace it and i wanna replace the whole thing with a t2 drive shaft, does anyone know if the t2 driveshaft will fit in the n/a driveshafts place???
#2
Doin a rebuild.
iTrader: (1)
Join Date: Aug 2004
Location: Roswell (atl ) Georgia
Posts: 539
Likes: 0
Received 0 Likes
on
0 Posts
The driveshaft is not just swappable, you will need a t2 diff, t2 halfshafts, t2 transmission, t2, clutch, t2 flywheel, etc. it's a relatively big swap.
you can not replace the tranny if you get the half t2 half na one : i believe mazdatrix has one.
You can also just have the ujoints replaced:
http://mazdatrix.com/g9.htm
Many local shops will likely be able to pull out the old ujoints and insert new ones.
you can not replace the tranny if you get the half t2 half na one : i believe mazdatrix has one.
You can also just have the ujoints replaced:
http://mazdatrix.com/g9.htm
Many local shops will likely be able to pull out the old ujoints and insert new ones.
Last edited by sar; 03-05-06 at 11:05 PM. Reason: add aftermarket
#3
Junior Member
Thread Starter
Join Date: Oct 2005
Location: Richmond, CA
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
driveshaft
yea, but i rear is shot soo i think i need to replace the whole thing...so i may grab one of the aftermarket ones from mazda trix. thanks anyways
#4
Thread
Thread Starter
Forum
Replies
Last Post