doing a convertion need help!
09-30-05, 10:43 AM
#1
yeah its a rotary
Thread Starter
iTrader: (1)
Join Date: Aug 2005
Location: Va Beach or IN, indianapolis
Posts: 795
Likes: 0
Received 0 Likes
on
0 Posts
doing a convertion need help!
hay all does anyone know any site with pics and a step by step instructions? i need one for the engine harness as to how it is conneted to the motor.i have a 87 turbo 2 . IM SO CLOSE to finishing this long awaiting project.......... 
.oh and also a blueprint of all the vacume lines as to where they start and end.
.oh and also a blueprint of all the vacume lines as to where they start and end.
09-30-05, 11:06 AM
#2
Full Member
Join Date: May 2005
Location: Charlotte, NC
Posts: 73
Likes: 0
Received 0 Likes
on
0 Posts
I am staring my project tonight, I have a 91 n/a that is going to recieve a jspec turbo engine. over the last few weeks i have been researching extensively, and in my honest opinion, it is hard to beat the factory service manual (fsm). You may have to dig through several sections to find what you need, but it is all there. Also searching this site you can find pics of people's engines that will show you what you need. Everytime I came accross a pic of someones engine bay, I saved it so I have some reference material to go back to.
hope that helps, good luck
hope that helps, good luck
Thread
Thread Starter
Forum
Replies
Last Post