Does anyone know where this wire goes?
#1
Senior Member
Thread Starter
Join Date: Dec 2001
Location: Pittsburgh, PA
Posts: 383
Likes: 0
Received 0 Likes
on
0 Posts
Does anyone know where this wire goes?
Hello everyone.
Well two montsh back I was ripping out my N/A motor with the intention of swapping in a Cosmo motor so I wasnt doing it in the best way possible probbaly. Well after I got the engine out I noticed a wire plug just sitting on the ground with about 2 inches of wire attacted to it. I think I found the correct plug it goes to but Im confused as where the wire goes to. Im Putting my rebuild in this weekend so any help would be greatly apreciated. Cant wait to hear the exhuast on my car again. THANK!
-Stew
Well two montsh back I was ripping out my N/A motor with the intention of swapping in a Cosmo motor so I wasnt doing it in the best way possible probbaly. Well after I got the engine out I noticed a wire plug just sitting on the ground with about 2 inches of wire attacted to it. I think I found the correct plug it goes to but Im confused as where the wire goes to. Im Putting my rebuild in this weekend so any help would be greatly apreciated. Cant wait to hear the exhuast on my car again. THANK!
-Stew
#2
Senior Member
Join Date: Apr 2003
Location: New Idaho
Posts: 523
Likes: 0
Received 0 Likes
on
0 Posts
That look like it goes to the funny grounding-**** I never knew what these are called.....
I'll try my best to describe it.
On your clutch slave cylinder, the one that sits on your transmission there shoud be this black square thing attached to one of the bolts holding the slave cylinder to the tranny. And It probably has a broken wire attached to it now. It would be easy to miss because it can hide there especially if it has a lot of dirt and grime on it,
I'll try my best to describe it.
On your clutch slave cylinder, the one that sits on your transmission there shoud be this black square thing attached to one of the bolts holding the slave cylinder to the tranny. And It probably has a broken wire attached to it now. It would be easy to miss because it can hide there especially if it has a lot of dirt and grime on it,
#3
Senior Member
Thread Starter
Join Date: Dec 2001
Location: Pittsburgh, PA
Posts: 383
Likes: 0
Received 0 Likes
on
0 Posts
Templeswain
I looked over my tranny as I was cleaning it off. Sure enough there is that stupid looking little black box right next to the slave cylinder. Looks like i must have missed it and riped it right off when the motor was pulled. Thanks alot!!!!
I looked over my tranny as I was cleaning it off. Sure enough there is that stupid looking little black box right next to the slave cylinder. Looks like i must have missed it and riped it right off when the motor was pulled. Thanks alot!!!!
Thread
Thread Starter
Forum
Replies
Last Post
toplessFC3Sman
2nd Generation Specific (1986-1992)
6
03-20-18 01:54 PM