DIY debadging?
#1
Senior Member
Thread Starter
Join Date: Jun 2007
Location: Seattle Washington
Posts: 598
Likes: 0
Received 0 Likes
on
0 Posts
DIY debadging?
I am thinking about debadging my FC. I dont want to get it done professionally ($500 estimate) and I dont want it to look like **** either. I heard the best method was to use a heat gun/dryer and heat it up until the adhesive melts and then peel it off with floss. How proficient is this method? Are there studs/pins in both the Mazda and the RX-7 badges or just one? Does anyone have any pictures of their debadged FC's or any better methods of doing so? Searched, but did not find. Thanks.
#2
I know my S4 has pins on the badges. Ive taken the badges off with a pocket screw driver. The previous owner had it painted to match the Turbo wing so there was no adhesive.
Thread
Thread Starter
Forum
Replies
Last Post
Mrmatt3465
Interior / Exterior / Audio
8
09-17-15 01:28 PM