diff/axle question
Thread Starter
Banned. I got OWNED!!!
Joined: Mar 2005
Posts: 526
Likes: 0
From: san antonio TX
diff/axle question
heres the deal
i am getting a tii diff with out the half shafts
i am getting tii axles with out half shafts
i am getting tii drive shaft
the question is.
can i use my N/A half shafts to bolt up to the TII axles
usualy the diff comes with those half shafts
the short part that sticks out of diff that bolts to axles is missing on this diff because he used his half shafts on a fd rear end swap
the splines were the same in fd and tii
are the splines the same on n/a and tii?
is the bolt pattern the same to the axles?
i am getting a tii diff with out the half shafts
i am getting tii axles with out half shafts
i am getting tii drive shaft
the question is.
can i use my N/A half shafts to bolt up to the TII axles
usualy the diff comes with those half shafts
the short part that sticks out of diff that bolts to axles is missing on this diff because he used his half shafts on a fd rear end swap
the splines were the same in fd and tii
are the splines the same on n/a and tii?
is the bolt pattern the same to the axles?
The half-shaft bolt pattern (and CV joint) is larger on the turbo, but the length, and outer spline at the hub, are all the same.
Last edited by vipers; Sep 1, 2006 at 03:12 AM.
Thread Starter
Banned. I got OWNED!!!
Joined: Mar 2005
Posts: 526
Likes: 0
From: san antonio TX
Originally Posted by vipers
The half-shaft bolt pattern (and CV joint) is larger on the turbo, but the length, and outer spline at the hub, are all the same.
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic S5 Turbo PNP Unit questions
_Tones_
Adaptronic Engine Mgmt - AUS
10
May 25, 2021 05:37 AM
Nosferatu
2nd Generation Specific (1986-1992)
7
Sep 5, 2015 02:13 PM