damn t2 giving me crap with clutch!
#1
I AM A THIEF - READ GOOD/BADGUY SECTION!
Thread Starter
Join Date: May 2002
Location: massachusetts
Posts: 225
Likes: 0
Received 0 Likes
on
0 Posts
damn t2 giving me crap with clutch!
ok i was trying to bust out but when i try to shift into 3rd past 4 1/2rpm the gear just gets grinded up and it doesnt go in, im like slaming on my clutch while its doing that. right after i did that i shifted into 5th and it grinded a bit when it was going in. plz just tell me im a moron driver and i should drive right. or could some thing be wrong with the clutch? i was thinking that my clutch petal isnt goin down all the way, i cant think of anything else. thanks! dudes! oh yeh i think i got an upgraded clutch but i really dont know. lets just say its stock.
#2
Eats, Sleeps, Dreams Rotary
iTrader: (1)
A little more info. How does the trans shift if driven normally. If no grinding on upshifts or downshifts then the trans should be ok. Hold clutch pedal to the floor for 1 minute, replease slowly until the pressure plate is released. If there is more than normal pedal travel, possible hydralics problem.
#3
Rotary Enthusiast
Join Date: May 2002
Location: Boston
Posts: 1,203
Likes: 0
Received 0 Likes
on
0 Posts
Yeah flip i think its your shifting thats ****** you up, jaja
Seriuosly though it sounds like your tranny is F'ed up i mean if its grinding like that in other gears other than first now id say its your tranny, cuz you clutch feels really good when i drive it. Ill check it out once i get out there which will be soon dont worry. My cuz is leaving soon so i gotto spend some time with her before she leaves you know how it is.
Seriuosly though it sounds like your tranny is F'ed up i mean if its grinding like that in other gears other than first now id say its your tranny, cuz you clutch feels really good when i drive it. Ill check it out once i get out there which will be soon dont worry. My cuz is leaving soon so i gotto spend some time with her before she leaves you know how it is.
Thread
Thread Starter
Forum
Replies
Last Post
83revival
New Member RX-7 Technical
4
09-03-15 10:42 PM