cutch sticking
#1
Full Member
Thread Starter
Join Date: Jan 2002
Location: Buford, GA
Posts: 139
Likes: 0
Received 0 Likes
on
0 Posts
cutch sticking
hey guys,
I got my 87' rx-7 running really good now but sometimes when I am stopped and I go to shift to 1st or 2nd teh clutch is stuck down to teh floor and I have to pop it up with my foot. What is this? Does it need fluid or what? Oh and what is the normal operating temp. on teh rx-7 13b non turbo?
I got my 87' rx-7 running really good now but sometimes when I am stopped and I go to shift to 1st or 2nd teh clutch is stuck down to teh floor and I have to pop it up with my foot. What is this? Does it need fluid or what? Oh and what is the normal operating temp. on teh rx-7 13b non turbo?
#3
Full Member
Join Date: May 2001
Location: pensacola, fl
Posts: 79
Likes: 0
Received 0 Likes
on
0 Posts
if the fluid is at a normal level, then you have air in the hydraulic system. this is caused by the internal seals leaking, this equals a need for a new clutch master cylinder. not too expensive if you change it your self, maybe $70. good luck!
Thread
Thread Starter
Forum
Replies
Last Post
imitek
3rd Generation Specific (1993-2002)
3
09-22-15 11:29 PM