crank angle sensor cover
06-30-05, 09:30 PM
#38
Senior Member
Thread Starter
Ok, anodized is $15 engraved. that will be the most you'll pay.
These things should not cost no more than $15.
So there you go.
Oh, and thanks very much for your interest.
These things should not cost no more than $15.
So there you go.
Oh, and thanks very much for your interest.
07-01-05, 02:29 AM
#40
Rotary Enthusiast
Join Date: May 2004
Location: SoCal
Posts: 1,325
Likes: 0
Received 0 Likes
on
0 Posts
BTW unless you want to run into the same problem as the guy remaking shifters to short shifters.... you should ask people to send you their old covers... unless you're making these things out of completely new material... in which case, ignore that I said anything. (I'd buy one if I had more money heh)
Oh, and see if you can get in with someone at a booth at SS8 to sell them there... I was contemplating buying a rotor keychain for a while, then I saw them at SS7 and bought one on the spot... so yeah.
--Gary
Oh, and see if you can get in with someone at a booth at SS8 to sell them there... I was contemplating buying a rotor keychain for a while, then I saw them at SS7 and bought one on the spot... so yeah.
--Gary
07-08-05, 10:31 AM
#43
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
Now, those anodized ones are pretty cool. I still like mine though. It's clear.
Now, the obligatory moderator comments. If you are intended to see these things on the forum, and/or start a group buy, you need to be approved by the Admins. PM Jason or BOOSTD 7 for details.
Now, the obligatory moderator comments. If you are intended to see these things on the forum, and/or start a group buy, you need to be approved by the Admins. PM Jason or BOOSTD 7 for details.
07-11-05, 01:12 PM
#49
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
Not sure what's going on here...
If you are selling these things, you need approval from the forum admins to become a vendor and post ads here. Nothing wrong with selling a few in the for sale/wanted area, but if you intend to advertise and sell in the 2nd gen forum, you need to be a vendor.
If people are complaing about service, then they should take it to PMs. Please do not post questions about shipping, payment, etc. in public threads.
If you are selling these things, you need approval from the forum admins to become a vendor and post ads here. Nothing wrong with selling a few in the for sale/wanted area, but if you intend to advertise and sell in the 2nd gen forum, you need to be a vendor.
If people are complaing about service, then they should take it to PMs. Please do not post questions about shipping, payment, etc. in public threads.
07-12-05, 09:17 AM
#50
Senior Member
Thread Starter
I'm not a company or anything like that I just have access to machinery at my job.
I didn't think I would get any interest.
It was just somethiing to do on my spare time.
I didn't think I would get any interest.
It was just somethiing to do on my spare time.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
