coolant feed fitting on s4 turbo
Thread Starter
Senior Member
Joined: Oct 2002
Posts: 432
Likes: 0
From: Chesapeake, Va
coolant feed fitting on s4 turbo
I am using an s4 turbocharger to turbocharge my first gen. Anyways, I about have the project wrapped up, but I need to know what the threading is on the coolant feed fitting on the turbocharger. Thanks for the help
Woops. NM.
Hmm I have an extra banjo from the coolant at my house. I think an extra inlet piece as well.
PM tonight to remind me and I'll check them out. I don't think I'll have a size but I will try and get the thread spacing on them(using a tap tooth scale thing)
Oh yeah.
Ret Your thinking of the oil part. Those are flanged.
The coolant is Banjo bolted.
Hmm I have an extra banjo from the coolant at my house. I think an extra inlet piece as well.
PM tonight to remind me and I'll check them out. I don't think I'll have a size but I will try and get the thread spacing on them(using a tap tooth scale thing)
Oh yeah.
Ret Your thinking of the oil part. Those are flanged.
The coolant is Banjo bolted.
Last edited by Digi7ech; Jun 4, 2004 at 08:42 PM.
HAILERS
Joined: May 2001
Posts: 20,563
Likes: 27
From: FORT WORTH, TEXAS,USA
So I took the fitting off the car and it measures a quarter inch .....inside diameter. That's if your talking about the inside dia of the water pipe. This jpg from the site that will let you post jpgs http://www.teamfc3s.org/forum/showth...threadid=30356
Anything else you want to measure??? Eccentric shaft bearings???? Eccentric shaft oil holes?
Anything else you want to measure??? Eccentric shaft bearings???? Eccentric shaft oil holes?
Lives on the Forum
Joined: Feb 2001
Posts: 26,664
Likes: 22
From: n
Originally posted by Digi7ech
Oh yeah.
Ret Your thinking of the oil part. Those are flanged.
Oh yeah.
Ret Your thinking of the oil part. Those are flanged.
You're right!
Sorry about the misinformation - I was fricken tired when I replied.
Thanx for the correction!
-Ted
