cold air induction
#1
cold air induction
need some opinions:
i am thinking about rigging a cold air induction on my 87 na.
i am going to purchase the side scoop from summit racing and mold it onto my hood just above my air filter. before i mold it to the hood i will cut a hole in the hood over the filter and back it up with mesh wire from home depot. i have a solution to keep out water so not concerned about it.
how do you think this will look. also how functional will it be with a cold air box around the filter.
I love my 7!
i am thinking about rigging a cold air induction on my 87 na.
i am going to purchase the side scoop from summit racing and mold it onto my hood just above my air filter. before i mold it to the hood i will cut a hole in the hood over the filter and back it up with mesh wire from home depot. i have a solution to keep out water so not concerned about it.
how do you think this will look. also how functional will it be with a cold air box around the filter.
I love my 7!
#3
Pegasus Racing has some pre-molded plastic or fiberglass scoops you could use. Typically, the most effiecient design is a NACA duct but that's for smooth laminar flow areas. Luckily the RX has a lot of good areas for duct mounting!
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
The1Sun
1st Generation Specific (1979-1985)
0
09-07-15 10:21 PM