2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Clutch/tranny and Brakes/ABS problems

Thread Tools
 
Search this Thread
 
Old Mar 21, 2004 | 02:30 PM
  #1  
eyecandy's Avatar
Thread Starter
Rotary Freak
Tenured Member: 20 Years
iTrader: (19)
 
Joined: Sep 2002
Posts: 2,928
Likes: 1
From: Pittsburgh,PA
Clutch/tranny and Brakes/ABS problems

Clutch/Tranny

When ever I go to engage the clutch in first gear to drive it feels like the car has a blow rotor, it does not want to move, its like sputtering, I try to rev the engine and it stays at or below 1200 rpm.... Its a brand new engine and clutch kit. The pedal feels normal (its been bleed) and strong, tranny shifts in all gears good, I have no clue as to what the problem would be....

Brakes/ABS

I have not brakes until its right abive the floor, the hand brake works. The brakes were bleed as well. Ever since I restarted the enigne the ABS light is on, the ABS unit was bleed as well.... Could the dead brakes have anything to do with the ABS?

I would really appreciate any help possible, right now I am at the point of either beating the **** out of the car, or selling everything and getting out of the RX7 business altoghter. I have one problem, and when that gets fixed another comes right up......
Reply
Old Mar 22, 2004 | 08:23 AM
  #2  
eyecandy's Avatar
Thread Starter
Rotary Freak
Tenured Member: 20 Years
iTrader: (19)
 
Joined: Sep 2002
Posts: 2,928
Likes: 1
From: Pittsburgh,PA
I was looking into it further and I think its a throttle problem not the clutch/tranny...

Does anyone make an ABS removal kit?
Reply
Old Mar 22, 2004 | 09:01 AM
  #3  
SureShot's Avatar
Seduced by the DARK SIDE
Tenured Member 15 Years
 
Joined: Apr 2001
Posts: 7,323
Likes: 2
From: Orange Park FL (near Jax)
ABS removal:
I saw a writeup but I forget where.
He bought the non-ABS brake tubes from Mazdatrix.
He then replaced the ABS lines with the stock ones from the rear T at the axle, all the way forward.
Reply
Old Mar 22, 2004 | 10:58 AM
  #4  
eyecandy's Avatar
Thread Starter
Rotary Freak
Tenured Member: 20 Years
iTrader: (19)
 
Joined: Sep 2002
Posts: 2,928
Likes: 1
From: Pittsburgh,PA
If you remember where you saw it please let me know.... I would rather keep it, but if the unit needs replaced, I do not want to spend $1200 for a new one. It was working fine before, now I have no brakes...
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
WyomingTII
2nd Generation Specific (1986-1992)
12
Sep 28, 2015 10:32 AM
lnlreaper
2nd Generation Specific (1986-1992)
2
Sep 27, 2015 09:59 AM
The1Sun
1st Generation Specific (1979-1985)
7
Sep 18, 2015 07:13 PM
The1Sun
New Member RX-7 Technical
5
Sep 15, 2015 04:45 PM




All times are GMT -5. The time now is 01:38 PM.