ok, heres the deal, when i got the car, the clutch was hanging, but the car would not go into gear. we put fluid in slave cyl. and pumped, it worked for 8 months.
car sat for 5 4 months.

fluid is greyish-black

clutch is on floor every morning

think i hear dripping near the fly wheel

1st and rev sometimes grind

noticable thunk, when i let out the clutch

bad trowout bear( can hear it)

...
why is the clutch on the floor, whats up with 1/r, please help.......

 

btw i don't really know much about clutchs........, but i need a ruff idea....

 

Sounds like u have a bad clutch slave cylinder.The slave is on the back drivers side of the engine,its held on by 2 10 or 12mm bolts,and the clutch fluid line.Take it off,pop off the rubber on top,and look inside u should see a round piece of rubber(or whatevers left of it).If the rubber is shot or wont slide freely,you need a new CLUTCH SLAVE CYLINDER.They cost about $50-$75,and take all of 15 mins. to change.
HOPE THIS HELPS!!!!

 

nope, IT IS NOT the slave cyl......., its perfectly fine.....

 

Then maybe the master cylinder?