i did an engine swap and changed the release bearing, cleaned the clutch disk, and the presure plate. i bled the clutch. now when i drive it the car does not move until the clutch is all the way out.

 

have you tried adjusting the clutch pedal?

 

Look under the Dash..On the Clutch pedal,where it Pivots(sort of) there Is an adjuster that allows the Pedal to Go UP or In..and also the ROD that goes to the Master Clutch cylinder Inside the car,has a nut on it where the rod attaches to the Arm of the pedal..adjust that..you will eventually Get a "Pedal feel" that you like..That is,If the Clutch was bled properly and you have no hydraulic issues..Good luck.

 

it was just a little air left in the line thanks guys