So i was driving cam up to a red like down shifting but had my clutch fully ingaged when i down shifted without releaseing the clutch something popped and now the clutch goes to the floor really easy can't put it in to gear but engine still runs fine just can't put it in gear any ideas as to what it might be?

 

Check your clutch hydraulics.

 

I second that.

 

hydraulic fluid or hydraulics and where would i look. I don't know to much about it.

 

Drivers side of the engine bay there is a small clutch master cylinder next to the brake master cylinder, make sure that has fluid in it. There is a hard line coming off that that attaches to a soft line, make sure that is in good condition. The soft line attaches to the slave cylinder, squeeze the boot and make sure there are no leaks. If everything checks out ok it's possible that the internal seal in the master cylinder is leaking internally and needs to be replaced.