2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Cigarette Lighter Wiring

Old Dec 3, 2001 | 02:14 PM
  #1  
NJDave's Avatar
Thread Starter
Full Member
Tenured Member 10 Years
 
Joined: Aug 2001
Posts: 112
Likes: 0
From: Northern New Jersey
Cigarette Lighter Wiring

When my car (89 convertible) was stolen, the thieves cut the wires to the cigarette lighter and took it. Cheapskates. Therefore, I now need help with the wiring for the new one. Also need some help with what type of connectors to use for connecting the cigarette lighter.

If you have ever pulled the lighter out (the part that stays in your dash normally), you will see two spade-like posts on the back. Therefore, I presume only two wires run to the lighter. However, there are 4 wires leading to that location:

1 - red w/green stripe
1 - blue w/brown or purple stripe
2 - black wires

Which two do I connect to my lighter. Does the trim ring around the lighter normally light up? (I can't remember). If so, which wires do I run to the light and what kind of light is back there. If there is a light back there, and anyone can even get me part numbers, I would be ecstatic - even the dealer can't answer my question!

Thanks,
Dave

Last edited by NJDave; Dec 3, 2001 at 02:37 PM.
Reply
Old Dec 3, 2001 | 04:29 PM
  #2  
ianbell's Avatar
Senior Member
Tenured Member 10 Years
 
Joined: Apr 2001
Posts: 327
Likes: 0
From: Cambridge
Yes the trim ring is illuminated - I think you will find the other two wires are for the bulb that lights up the interior of the ashtray.
Reply
Old Dec 3, 2001 | 04:35 PM
  #3  
Icemark's Avatar
Former Moderator. RIP Icemark.
 
Joined: Apr 2001
Posts: 25,896
Likes: 24
From: Rohnert Park CA
Normally there is a two pin plug that the wires then plug into the back of the cig lighter, these can be replaced by female blade terminals (local electronics store or radio shack- maybe .05 each) if the factory plug is bad or missing.

I m at work right now, so tonight when I get home I will look up to see which one goes where (you don't want to mix up the two if you ever plug anything like a radar detector in, or it will smoke the detector).

There is also a light, for the trim ring, that plugs into the radio bezel.
Reply
Old Dec 3, 2001 | 04:36 PM
  #4  
MaxRX7's Avatar
hambre y sueño
Tenured Member 10 Years
 
Joined: Feb 2001
Posts: 300
Likes: 1
From: 80* >
can't remember for sure.

black wires are always grounds. since there are 2 maybe one of the lighter and other for light ?

the red w/green stripe to the lighter or light, and the blue w/brown or purple stripe to the other.
Reply
Old Dec 3, 2001 | 04:37 PM
  #5  
NJDave's Avatar
Thread Starter
Full Member
Tenured Member 10 Years
 
Joined: Aug 2001
Posts: 112
Likes: 0
From: Northern New Jersey
OK - thanks guys.

Icemark - what do you mean the light connects to the radio bezel? - I see 4 wires back there - I assume that, as someone said above, that one black (ground?) and one colored wire go to each of the light and the cig lighter? Where does the radio bezel come into play? (oh, by the way, the radio was stolen also, so I have an aftermarket head unit now, Sony CDX-M770, if it matters).


Thanks again,
Dave

Last edited by NJDave; Dec 3, 2001 at 05:27 PM.
Reply
Old Dec 4, 2001 | 12:29 AM
  #6  
Keith's Avatar
Senior Member
Tenured Member 10 Years
 
Joined: Mar 2001
Posts: 501
Likes: 1
From: Lawrenceville,Georgia,U.S.
Red with green stripe is to the light for the ring around the cigarette lighter, the other wire (blue with black stripe according to my diagram, but close enough) is cigarette lighter power. Each black wire is a ground return for the above (2-wire pairs). Hope this clears it up for you!

Irv, Keith's dad
Reply
Old Dec 4, 2001 | 12:42 AM
  #7  
Icemark's Avatar
Former Moderator. RIP Icemark.
 
Joined: Apr 2001
Posts: 25,896
Likes: 24
From: Rohnert Park CA
Yep, the Radio bezel has a light on it around the cig lighter. A type 194 bulb (3 watt) and socket. Snap in or twist in depending on dash style.

Irv, Keith's dad is correct in that the Blacks.. they are ground (larger black to the outside of the cig lighter) and I have a LtBlue/Black as the 12v+ in hooked up to the center conductor of the cig lighter.
Reply
Old Dec 4, 2001 | 05:48 AM
  #8  
NJDave's Avatar
Thread Starter
Full Member
Tenured Member 10 Years
 
Joined: Aug 2001
Posts: 112
Likes: 0
From: Northern New Jersey
Thanks a lot guys! I've been sitting with this hole in my dash for a few weeks now, waiting to take it back in to have someone look at it. Now the wiring part is clear.

It appears that all I have to do now is 1) run to Home Depot/auto store and pick up the correct female spade connectors; and 2) get a 3w bulb and socket from Home Depot/auto store (I assume the sockets are pretty standard, right?); and 3) figure out where to mount the light (no stock radio to work with).

Thanks again - any ideas on the mounting of the light are greatly appreciated!

Dave
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
DocHoliday89
3rd Generation Specific (1993-2002)
5
Oct 12, 2015 07:42 PM
betes
1st Generation Specific (1979-1985)
8
Sep 27, 2015 08:25 AM
cosmo7
West RX-7 Forum
2
Sep 14, 2015 09:47 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 05:30 PM.