RX7Club.com - Mazda RX7 Forum

2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Center transmission crossmember nut size

Thread Tools
 
Search this Thread
 
Old May 3, 2011 | 10:56 PM
Share
  #1  
jaggermouth's Avatar
jaggermouth
Thread Starter
Will TIG for 20b
Tenured Member 10 Years
iTrader: (1)
 
Joined: Mar 2008
Posts: 1,422
Likes: 3
From: Nanaimo
Center transmission crossmember nut size
Hi, I need a nut for an S4 TII transmission center crossmember mount. It's not the two "45* angle" mounts, but the large center one. I need the thread pitch so I can find myself one.
Thanks
Reply
0
Old May 4, 2011 | 10:00 PM
Share
  #2  
misterstyx69's Avatar
misterstyx69
Retired Moderator, RIP
Tenured Member: 20 Years
iTrader: (142)
 
Joined: Sep 2005
Posts: 25,581
Likes: 136
From: Smiths Falls.(near Ottawa!.Mapquest IT!)
??..I gotta Brain fart on this
so, I went out and tried somethinn..
It is the same Physical size of a wheel stud,but fine thread..if that helps..(wheel studs are 12x1.5)
Reply
0
Old May 5, 2011 | 12:58 AM
Share
  #3  
jaggermouth's Avatar
jaggermouth
Thread Starter
Will TIG for 20b
Tenured Member 10 Years
iTrader: (1)
 
Joined: Mar 2008
Posts: 1,422
Likes: 3
From: Nanaimo
will give it a try, thanks a lot haha
Reply
0
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Turbo II brake help. Almost there.
Frisky Arab
2nd Generation Specific (1986-1992)
13
Aug 18, 2015 05:30 PM
1980 Anniversary Edition RX7 Conversion to TII 13B Journey - Draft
KAL797
Test Area 51
0
Aug 11, 2015 03:47 PM
Tags
Back to Subforum
2nd Generation Specific (1986-1992)
View Next Unread
TII Swap Won't Start, My Compression ok? (Videos inside)




Advanced Search

All times are GMT -5. The time now is 03:08 PM.