Catchcan mounting and routing
#1
Rotary Enthusiast
Thread Starter
Join Date: Jun 2003
Location: Millville, NJ
Posts: 1,424
Likes: 0
Received 0 Likes
on
0 Posts
Catchcan mounting and routing
How do you guys have your catchcan set up? Do you have both lines going to the nipple on the filler and block, or do you have one going back into the intake like stock? Also, where do you guys have it mounted? I cant seem to find a good place that wouldn't have to have alot of line run to it..
#2
Locust of the apocalypse
Join Date: Apr 2003
Location: Directly above the center of the earth (York, PA)
Posts: 2,553
Likes: 0
Received 1 Like
on
1 Post
I got a catch can off a buddy and i have the same problem, with the FMIC pipes, I aint got no place to mount the sucker... I have to go to a smaller can!
#3
Seduced by the DARK SIDE
Join Date: Apr 2001
Location: Orange Park FL (near Jax)
Posts: 7,323
Likes: 0
Received 2 Likes
on
2 Posts
I am using the old charcoal canister with some of the origonal hose & pipe directly from the top oil filler neck nipple.
The fuel vent hose is still origonal.
When it clogs up, I'll just swing by the junk yard - they have lots more.
The fuel vent hose is still origonal.
When it clogs up, I'll just swing by the junk yard - they have lots more.
#4
Rotary Enthusiast
Thread Starter
Join Date: Jun 2003
Location: Millville, NJ
Posts: 1,424
Likes: 0
Received 0 Likes
on
0 Posts
Hmm.. Good suggestion, but I have no charcoal canistor, I have my tank vented straight from the tank, and I have a Jegs Jaz Catchcan. I was thinking about mounting it right on my oil filler neck. Does that sound like a feasible idea?
Thread
Thread Starter
Forum
Replies
Last Post
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
10-09-15 10:05 PM
SakeBomb Garage
SakeBomb Garage
0
09-04-15 05:20 PM
SakeBomb Garage
Vendor Classifieds
0
09-04-15 05:19 PM