Car will crank...car won't start. Help!
#1
Boost in..Apex seals out.
Thread Starter
Join Date: Nov 2003
Location: Maryland, 21794
Posts: 1,931
Likes: 0
Received 0 Likes
on
0 Posts
Car will crank...car won't start. Help!
Ok, I just finished putting my T2 back together. It has been MONTHS!
So uh..I tried turning it over, the starter cranks, but the engine won't catch. What should I look for..?
All my fuses are good, both in the engine bay, and the interior. All my ground and power wires are run correctly, all my vacuum hoses are run correctly, etc.
Edit: HAS compression. Already checked.
So uh...?
So uh..I tried turning it over, the starter cranks, but the engine won't catch. What should I look for..?
All my fuses are good, both in the engine bay, and the interior. All my ground and power wires are run correctly, all my vacuum hoses are run correctly, etc.
Edit: HAS compression. Already checked.
So uh...?
Last edited by adrock3217; 07-13-06 at 01:02 PM.
#2
Boost in..Apex seals out.
Thread Starter
Join Date: Nov 2003
Location: Maryland, 21794
Posts: 1,931
Likes: 0
Received 0 Likes
on
0 Posts
Ok. I have spark, no vacuum leaks that I can tell, and fuel. I know I have fuel, because there is a 3' puddle under my car of the stuff. Happy day...? No..
#3
knowledge junkie
If you have spark & fuel, might just need to re-establish the oil film inside the engine to prevent compression blow-by. Drop 1-2 capfuls of ATF in each leading sparkplug hole. Also assuming you put all the grounds back on.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
rx8volks
Canadian Forum
0
08-11-15 10:30 PM