i have a 88 se rx7 with a turbo 2 engine and drive train. i can not power shift any gear. i can hardly shift it i have to wait till the rpms are all the way down most of the time. i have a lot of experience with this car and other cars so im not a noob. i put a new slave cylinder on it and bled it and bled it. still the same problem. the clutch never slips. i can do a second gear dump no trouble. it will blow the tires off in 3rd no trouble slipping. when i push the clutch in while its idling it takes a minute for the tranny to stop spinning. u can hear it inside the car. i mean what do u guys think could be causing this? just 10 minutes ago i bled it out atleast 6 times. held it to the floor and i opened the bleeder then closed it and pumped it. did this 6 times. it doesnt leak any clutch fluid out. i would take any opinions you guys have. thanks ryan

 

Kind of sounds like synchros but the taking a minute to spin down sounds clutch related

anyhow, heres a bump

 

Time to change your trans fluid. My car sat for 2.5 years, and trans would wine and be often hard to go into gear when I was driving again. Sometimes I found myself trying 2 or 3 times, while driving, putting the car into 3rd gear! After changing the fluid the trans is silent and I can shift perfect.

 

the fluid isnt 6 months old.

 

Bad Pilot bearing maybe, clutch not fully dissengaging.