2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

buzzing fuel injectors WTF!!!!!!

Thread Tools
 
Search this Thread
 
Old Apr 8, 2002 | 10:11 PM
  #1  
LLADNAR's Avatar
Thread Starter
Senior Member
Tenured Member 05 Years
 
Joined: Nov 2001
Posts: 273
Likes: 0
From: Carbondale, KS
Angry buzzing fuel injectors WTF!!!!!!

i bought these injectors 65# per hour low impedence injectors for my 87 t2 now with them plugged in and the key on they make a horrible buzzing noise,,what the hell is the deal,,is there anything i can do besides putting the old rusty shito injectors back?
Reply
Old Apr 9, 2002 | 12:32 PM
  #2  
LLADNAR's Avatar
Thread Starter
Senior Member
Tenured Member 05 Years
 
Joined: Nov 2001
Posts: 273
Likes: 0
From: Carbondale, KS
TTT
Reply
Old Apr 9, 2002 | 02:26 PM
  #3  
Aaron Cake's Avatar
Engine, Not Motor
Tenured Member: 20 Years
iTrader: (1)
 
Joined: Feb 2001
Posts: 29,798
Likes: 128
From: London, Ontario, Canada
If the injectors are used, sounds like they need to be cleaned. Remember that high/low cutoff for injectors was 87.5, so you may have the wrong injectors for your car. Check the Mazdatrix site under the fuel section for the exact VIN numbers where the injectors changed.
Reply
Old Apr 9, 2002 | 03:36 PM
  #4  
LLADNAR's Avatar
Thread Starter
Senior Member
Tenured Member 05 Years
 
Joined: Nov 2001
Posts: 273
Likes: 0
From: Carbondale, KS
well i deceded to test this out,,so i take out my new expensive injectors,,and just plug in my old ones and they buzz too,,,then i get out my DVOM and test the wiring,,,i have 12v on one side and .25-.5v on the other,,so the injectors are getting power on both sides

which brings up a question,,i saw a thread about grounding you injectors,,could i just do that and not worry about it. by the way the secondaries are the only ones doing this
Reply
Old Apr 9, 2002 | 04:07 PM
  #5  
Aaron Cake's Avatar
Engine, Not Motor
Tenured Member: 20 Years
iTrader: (1)
 
Joined: Feb 2001
Posts: 29,798
Likes: 128
From: London, Ontario, Canada
Your secondaries should not be receiving power until the engine is under load and spinning faster than 3500 RPM. Sounds like a wiring problem.
Reply
Old Apr 9, 2002 | 07:55 PM
  #6  
LLADNAR's Avatar
Thread Starter
Senior Member
Tenured Member 05 Years
 
Joined: Nov 2001
Posts: 273
Likes: 0
From: Carbondale, KS
that is very strange
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
EfiniGirl
Haltech Forum
2
Sep 1, 2015 09:31 PM
82streetracer
1st Generation Specific (1979-1985)
7
Aug 23, 2015 09:28 AM




All times are GMT -5. The time now is 10:15 AM.