2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Buying 88T2....advice?

Thread Tools
 
Search this Thread
 
Old Aug 1, 2006 | 11:05 AM
  #1  
dipsetunion's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Mar 2006
Posts: 86
Likes: 0
From: NC
Buying 88T2....advice?

A friend of mine found a 88 Turbo II with 94k on it....red paint, gray leather....says it runs perfectly fine but smokes a little bit due to a blown seal...(i think he said oil seal)...the guy wants 1300 OBO for it.....i know its going to need a rebuild very soon but im thinking he could get it for like 800-900 bucks because the owner doesnt know he needs a rebuild.....worth it?
Reply
Old Aug 1, 2006 | 11:30 AM
  #2  
mort2002's Avatar
Rotary Enthusiast
Tenured Member 10 Years
iTrader: (1)
 
Joined: Jul 2003
Posts: 1,248
Likes: 0
From: Prosser Washington
if it runs i wold than i would put a seal kit and some new apex seals in and call it done and drive it.. you could have a TII for under 2k....
Reply
Old Aug 1, 2006 | 11:58 AM
  #3  
My5ABaby's Avatar
Rotaries confuse me
Tenured Member 10 Years
iTrader: (7)
 
Joined: May 2006
Posts: 4,219
Likes: 3
From: Murfreesboro, TN
Couldn't it be something like a leaking turbo?
Reply
Old Aug 1, 2006 | 12:13 PM
  #4  
mort2002's Avatar
Rotary Enthusiast
Tenured Member 10 Years
iTrader: (1)
 
Joined: Jul 2003
Posts: 1,248
Likes: 0
From: Prosser Washington
yea i it could be a bad turbo too. but you always have to look at it in the worst case senario.. i would assume the worst but hope for the best.. if tha makes sence. look at the good side though. if the motor only has bad oil control rings it will run like that for a while. but when you go to rebuild it all of the internals and housings inad iorns should be good since its not a blown rotor only a whiped out seal.. if the interior is good and body is decent i dont really see a down side.
Reply
Old Aug 1, 2006 | 02:50 PM
  #5  
Dcrasta's Avatar
Senior Member
Tenured Member 10 Years
 
Joined: Sep 2002
Posts: 408
Likes: 0
From: WDC
Ya check the compression. Hopefully its not modded too much. Check the cooling (Take it out during the day and see if it gets hotter than 1/3 on the temp gauge with the AC on max). Should shift smoothly, tight drivetrain/suspension/brakes. Steering should be smooth. Anything else is rebuildable. IF your getting a complete car 1200 isnt bad.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
SakeBomb Garage
SakeBomb Garage
9
May 11, 2020 10:04 AM
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
Oct 9, 2015 10:05 PM
Cameron38
1st Gen General Discussion
2
Sep 19, 2015 11:45 PM
mulcryant
2nd Generation Specific (1986-1992)
10
Sep 9, 2015 05:24 PM




All times are GMT -5. The time now is 11:52 AM.