bridgeport measurements
#1
Auto-Ex Noob
Thread Starter
iTrader: (1)
Join Date: Nov 2003
Location: new hampshire
Posts: 209
Likes: 0
Received 0 Likes
on
0 Posts
bridgeport measurements
i have searched but i cant seems to find specific measurements on the eyebrow location and width and what nots. Its for a s4 6-port. Does anyone have a picture with these on it or perhaps the numbers??
--thanks
joe
--thanks
joe
#2
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
You'll need to make your own template as none exist for the 6 port.
You limit is basically the seal groove on the iron (don't cut into it or you will catch the side seals) and then the water jacket top and bottom. If you want to start cutting into the rotor housing, then the limit is the water seal.
You limit is basically the seal groove on the iron (don't cut into it or you will catch the side seals) and then the water jacket top and bottom. If you want to start cutting into the rotor housing, then the limit is the water seal.
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM