Brake Qs
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Feb 2007
Location: Winnipeg
Posts: 290
Likes: 0
Received 0 Likes
on
0 Posts
Brake Qs
I'm a first gen guy, but I've built a complete 2nd gen front end to go in my first gen.
Couple questions.
I searched for the first one and couldn't find anything, so I'll just ask the others while I'm here...
1. The bearing races on my front hubs are pressed so far in I can't get a punch on them. What's the best way to get these things out?
2. Are front and rear brake rotors different diameters?
3. Anybody have a good source for remanned calipers?
Thanks guys!
Couple questions.
I searched for the first one and couldn't find anything, so I'll just ask the others while I'm here...
1. The bearing races on my front hubs are pressed so far in I can't get a punch on them. What's the best way to get these things out?
2. Are front and rear brake rotors different diameters?
3. Anybody have a good source for remanned calipers?
Thanks guys!
#2
Can Post Only in New Member Section
iTrader: (2)
Join Date: Jul 2004
Location: Calgary, Canada
Posts: 930
Likes: 0
Received 0 Likes
on
0 Posts
1. use a dremel/die grinder to put notches in the hub 180degrees apart. punch races out. debur notches. press new races in.
2. fronts are slightly larger. thicker, different offset and different hub size.
3. mazda trix has rebuild kits. it's remarkably easy to do.
2. fronts are slightly larger. thicker, different offset and different hub size.
3. mazda trix has rebuild kits. it's remarkably easy to do.
Thread
Thread Starter
Forum
Replies
Last Post
Tem120
3rd Generation Specific (1993-2002)
4
09-07-15 09:53 AM